GE DS3800HAIC1A1A 具有 1 个 20 针连接器和多个测试点
产品描述
GE稳压板DS3800HAIC1A1A具有用于连接到驱动器的模块化连接器和固定杆,用于将板固定在驱动器中。GE 稳压板DS3800HAIC1A1A还装有 9 个跳线和 2 个微调电阻器组件。该板还具有 1 个 20 针连接器和多个测试点。
该板设计为易于安装和从驱动器上拆卸。该板的背面有一个模块化连接器,与板架后部的匹配模块化连接器相接。安装人员将电路板滑入机架并按压电路板,直到模块化连接器相遇。然后,安装人员向下按下固定杆,直到固定杆锁定到位。此时,模块化连接器已完全就位并安装电路板。但是,有一些注意事项需要牢记。将电路板插入机架时,请仅握住电路板的边缘。这样可以防止用手指向下按压组件而对组件造成损坏。另外,不要让板子在金属板架上刮擦。对机架有良好的视野,并小心地滑入电路板,而不会将组件撞到机架上。
安装板后,您可以连接 20 针连接器。20 针连接器连接到带状电缆上,用于发送和接收来自驱动器中其他板的信号。如果需要卸下电路板,请先断开 20 针带状电缆。握住连接到电路板的带状电缆末端的连接器。
GE DS3800HAIC1A1A 具有 1 个 20 针连接器和多个测试点
Product description
The GE pressure stabilizer DS3800HAIC1A1A has a modular connector for connecting to the drive and a retainer rod for securing the board in the drive. The GE pressure stabilizer DS3800HAIC1A1A also has nine jumpers and two trimmer resistor assemblies. The board also features a 20-pin connector and multiple test points.
The board is designed to be easy to install and remove from the drive. The back of the board has a modular connector connected to the matching modular connector at the rear of the board frame. The installer slides the board into the rack and presses the board until the modular connector meets. The installer then presses down on the retaining rod until it locks into place. At this point, the modular connector is fully in place and the circuit board is installed. However, there are a few caveats to keep in mind. When inserting the board into the rack, only hold the edge of the board. This prevents damage to the component by pressing it down with your fingers. In addition, do not allow the board to scratch on the metal frame. Have a good view of the rack and slide into the board carefully without knocking the components into the rack.
After installing the board, you can connect the 20-pin connector. A 20-pin connector is attached to a ribbon cable for sending and receiving signals from other boards in the drive. If you need to remove the circuit board, disconnect the 20-pin ribbon cable first. Hold the connector at the end of the ribbon cable attached to the circuit board.
GE DS3800HAIC1A1A 具有 1 个 20 针连接器和多个测试点
ABB DCS ABB CPU模块 DSPC-170 57310001-GL/7 控制板 DSPC170 库存 ABB 83SR04E-E GJR2390200R1211 电源 电子模块
ABB DCS ABB CPU模块 PM860AK01 控制器单元 3BSE066495R1 PM 860AK01 ABB A GJR5253000R0100 机器人控制系统备件
ABB DCS ABB DSAI155 热电偶模块 57120001-HZ DSAI-155 输入板 ABB GJR5252711P4 热电阻 电源模块
ABB DCS ABB DSAI155A 带涂层 热电偶模块 3BSE014162R1 DSAI 155A Abb GJR5240100R107 IO/DO模块
ABB DCS ABB DSAO110A 输出模块 57160001-K/3 DSAO-110A PLC板卡 ABB GJR5251300R0101 07KT93D 热电偶 电源模块
ABB DCS DSDI146 3BSE007949R1 ABB模拟输入单元 31 通道 电源模块 ABB 07KT97F1 GJR5253000R0100 启动器
ABB DCS DSAX110A ABB模拟输入/输出板 DSAX-110A 3BSE018291R1 I/O模块 ABB GJR5251400R0202 07DC91C PLC变频器
ABB DCS ABB DSAX110 I/O模块 57120001-PC 输入输出模块 DSAX-110 ABB XS326A-E GJR2 2946 00 通道数字输入