133396-01 接近传感器 模块卡件

133396-01 接近传感器 模块卡件

R滚动轴承振动 注:  该监测器通道成对组态，一次zui多可执行上述功能中的2 个。通道1 和通道2 执行一个功能，通道3 和通道4 执行另一个功能或同一功能。

3500/40M 监测器的主要功能为:   

1)  通过连续不断地将机器振动当前值与组态中的报警值进行比较，并驱动报警系统，从而达到保护机器的目的；

2)  为操作人员和维护人员提供关键设备的振动信息。

通过组态，每一通道通常将输入信号处理成“静态值”。每一静态值都有组态好的警告报警值，每两个静态值都可组态一个危险报警值。报警的延迟时间可通过软件设定。

前面板LED（发光二极管）OK LED: 指示3500/40M 正常运行

TX/RX LED: 指示3500/40M 正与3500 框架内其它模块通讯  Bypass LED: 指示3500/40M 处于旁路模式

133396-01 接近传感器 模块卡件

R Rolling bearing vibration Note: The monitor channels are configured in pairs to perform up to 2 of the above functions at a time. Channels 1 and 2 perform one function, and channels 3 and 4 perform another function or the same function.

The main functions of the 3500/40M monitor are:

1) By continuously comparing the current value of the machine vibration with the alarm value in the configuration, and driving the alarm system, so as to achieve the purpose of protecting the machine;

2) Provide vibration information of critical equipment for operators and maintenance personnel.

Through configuration, each channel usually processes the input signal into a "static value". Each static value has a well-configured warning alarm value, and each two static values can be configured with a danger alarm value. The alarm delay time can be set by software.

Front panel LED (Light Emitting Diode) OK LED: indicates normal operation of 3500/40M

TX/RX LED: indicates that the 3500/40M is communicating with other modules in the 3500 frame Bypass LED: indicates that the 3500/40M is in bypass mode