330104-00-05-10-02-00 电涡流传感器探头

330104-00-05-10-02-00 电涡流传感器探头

每个键相器模块可接收2 个来自涡流传感器或电磁传感器的信号。输入信号范围为-0.8V到-21.0V(非绝缘I/O 模块)和+5V到-11V(绝缘I/O 模块)。模块内可限幅，使信号不得超过此范围。无源电磁传感器要求轴转速大于200rpm(3.3Hz)。在框架前面板上，通过同轴接头，有2 个缓冲键相位输出信号。2 个缓冲键相位输出同样可在框架背面，通过欧式接头得到。前面板发光二极管 OK 指示灯: 可指示在键相器模块内检测到一个故障。

TX/RX 指示灯: 当键相器模块与框架接口模块(RIM)进行通讯时，发出指示。

1) 缓冲的传感器输出

2) I/O 模块，绝缘内部端子

3) I/O 模块，绝缘外部端子

4) I/O 模块，非绝缘内部端子

5) I/O 模块，非绝缘外部端子

6) 带安全栅的I/O 模块，内部端子

330104-00-05-10-02-00 电涡流传感器探头

Each key phaser module can receive 2 signals from eddy current sensors or electromagnetic sensors. The input signals range from -0.8V to -21.0V(uninsulated I/O modules) and +5V to -11V(insulated I/O modules). The module can be clipped so that the signal does not exceed this range. The shaft speed of a passive electromagnetic sensor must be greater than 200rpm(3.3Hz). On the front panel of the frame, through the coaxial connector, there are 2 buffer keys phase output signals. The 2 buffer key phase outputs are also available on the back of the frame via European joint. Front panel LED OK indicator: indicates that a fault has been detected in the key phaser module.

TX/RX indicator: indicates when the key phaser module is communicating with the Frame Interface module (RIM).

1) Buffer the sensor output

2) I/O module, insulated internal terminals

3) I/O module, insulated external terminals

4) I/O module, non-insulated internal terminals

5) I/O module, non-insulated external terminals

6) I/O module with safety gate, internal terminals

330104-00-05-10-02-00 电涡流传感器探头